An impossible design? Think of dip moulding!

Do you need to make a new product, but you don’t know the best way how? Worried about expensive set-up costs? Why not try dip moulding!

The picture bellow gives you a good example. A product used in agriculture, made in a strong and durable material, required in small quantities and which should not be too expensive.

We have recently produced this product, 95 shore A material (quite tough), 200-400 pieces, and still very affordable. Even the tooling investment is very acceptable. With injection moulding this would have been a very expensive product.

Do you have a product that needs to be protected or decorated? Maybe you may think it’s an expensive or impossible design, but send us your drawing or sketch (info@loven-sp.com) and a few weeks later a finished product could arrive on your desk.

<< Back to News

Dip moulding advantages

- low costs for the prototype of the mould
- low costs for the production of the mould
- also interesting for small amounts
- short delivery times
- materials with glossy and matt finish possible
- a lot of standard colours available
- stress-free (long service life)

• Dip moulding
• Dip moulding materials
• Dip moulding advantages